why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified l

why we transfer FA(full arc) to PA(partial arc) in steam
turbine at specified load?

Question Posted / mujahid ali

No Answer is Posted For this Question
Be the First to Post Answer

More Mechanical Engineering Interview Questions

• Why do you think you would do well at this job?

What is galvanic corrosion?

What is gd&t?

Explain how does the pulley belts are to be aligned?

what is meant by parallax error

how water evaporated in sea

Why coupling should be located very near to the bearing? Why lap joint not recommended for tensile force?

Between steel, copper and brass, which conduct faster heat.

What is the different types of surge tanks ?

What are all the possibilities discharge will be low in the pumps?

For hot water : please compare to solar heat and heat pump (environment/operation/invest...) Is there any comparison available. Thank you

How is natural gas better than lpg?

For more Mechanical Engineering Interview Questions Click Here