what is iron loss?
Answers were Sorted based on User's Feedback
Answer / s . v. shinde
Itis noload power loss in a transformer on open ckt.and
equal to sum of eddy currentloss and hysterisis loss.
(copper loss is negligible in this condition)
| Is This Answer Correct ? | 17 Yes | 0 No |
Answer / arif latif
every motor, generator, transformer consist cover where
winding is fixed, the loss in winding in form of eddy
current or hysteresis is known as iron loss.
| Is This Answer Correct ? | 1 Yes | 2 No |
Answer / rahul deo maurya
loss by iron winding is iron loss.....
| Is This Answer Correct ? | 2 Yes | 11 No |
how to take the 3 phase ups input and collect single phase output
Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?
How to Calculate Transformer Earthing Electrode Rod Size both Body and neutral Earthing ? Any Standard Formula? Please Suggted
The simple way of finding the leakage quantity and % in compressed air distribution system
what will happen if the secondary of current transformer kept open....
Which motor runs on both ac and ac? a) dc series motor b) reluctance motor
solar cell voltage?
What will hapen if we run generator below 47.6hz frequency?
what is pressure relief valve?where it is used????
A 11 KV motor is working. if the supplay is fail. what will happened with it's breaker? Trip / remain the same condition?
when we start the tube light, then it takes initially 1100 volt, after glow it takes 120 volt?(when we give 220 volt a.c.)
direction of tarbine& genrator
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)