Answer / manjunath

yes, absolutely ..they use petrol & diesel bcoz it is highly
inflammable as compared to any other fuels ...

Answer / ankur verma

No, the type of fitting & design does not vary for automotive
segment. Its the same. However, its different in case of
aerospace & other sector.
In the fittings, usually of hole/shaft one of those is made at
the basic size so that it can accommodate the other one.

Tell me about a time when you surmounted a major obstacle.

0 Answers   Ashok Leyland,

---

List 5 words that best Describe your strengths? List 5 words that best Describe your weakness?

0 Answers   Kirloskar,

---

what is a stage time

0 Answers   Honda,

---

What is kingpin offset? State some of its application.

0 Answers  

---

What is a pneumatic system and where is it used?

0 Answers   Ashok Leyland,

---

---

What is bearing and what are the different types of bearing ?

0 Answers   GM General Motors,

---

What stands for ac in ac mechanical fuel pump?

0 Answers  

---

What are the troubles in inaccurate gauge reading?

0 Answers  

---

What is an injector pressure in heavy vehicle?

0 Answers  

---

What is diff between SCADA nad DCS,Present which is new technology, Is dcs controls with out manual operation?

1 Answers  

---

Differentiate between stress and strain.

0 Answers   Ashok Leyland,

---

The main advantage of single plate clutch over cone clutch is a) Easier gear changing b) Less binding of contact surfaces c) Less pedal movement d) all of the above

0 Answers   Backbone, Bosch, MAHINDRA, Uniparts Group,

---