Answer / kc kasaudhan

generally the steam turbine is shown in horizontal v-shape
position which indicate that the blades will be smaller for
high pressure side and slight big for medium pressure and
bigger for low pressure this to compensate the expanded
volume of a steam in a turbine

so

small size blade = high pressure
medium size blade = medium pressure
long size blade = low pressure

Answer / salai jeyaveeran

generally the steam turbine is shown in horizontal v-shape
position which indicate that the blades will be smaller for
high pressure side and slight big for medium pressure and
bigger for low pressure this to compensate the expanded
volume of a steam in a turbine

so

small size blade = high pressure
medium size blade = medium pressure
long size blade = high pressure

Answer / sekhar m ch

small size blade-high pressure
medium size blade -medium pressure
big size blade-low pressure

Answer / venkatesh

Also by blade sections...
The LP blades are more kind of open sections while HP blades
are closed type (with higher inlet & outlet angles)...

Answer / abhishek

Impulse, reaction and impulse-reaction turbine blades are
the types of turbine for high , low pressure.

what will be the velosity of a water at in the pipe of 6 inches which is situated at the bottom of 10 mtr tank ?

1 Answers   Essar,

What is the difference between first angle and third angle

1 Answers   Ultra Engineers,

Purpose of governer in automobile?

14 Answers  

difference between a tower and vessel

3 Answers  

what is turbo machine

9 Answers   L&T,

tansen was singer in whose mugal emperor

3 Answers   Concor,

what is EEE in thermodynamics?????

3 Answers   ME,

WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C

0 Answers   TATA,

what is the difference between cold and hot spark plug? mention their place of use with justification?

0 Answers   Hero Honda,

what is continuous-emission monitoring(CEM)System?

1 Answers  

wat is the need to run a machine without feed???

1 Answers  

what is the tool holding system?

1 Answers