Interested to Buy Any Domain ? << Click Here >> for more details...
What PPP frame initiates the network layer protocols to be
used during a connection?
- 1 Answers
- 3632 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: Network Control Protocol (NCP)
This protocol establishes and configures different Network
layer protocols and is designed to allow the simultaneous
use of multiple Network layer protocols.
| Is This Answer Correct ? | 0 Yes | 0 No |
What are metrics used with IGRP? A. Ticks B. Load C. Hops D. Delay
Diagramming application information flow is important because: A. it helps identify heavy traffic paths B. it helps figure out why email gets from one place to another C. it can tell you when to purchase a new router D. it can tell you when to purchase a new switch
Which of the following three sets of IP addresses and subnet masks are private IP addresses? A. 10.0.0.0 255.0.0.0 B. 172.16.0.0 255.255.0.0 C. 172.16.0.0 255.240.0.0 D. 192.168.0.0 255.255.0.0
How can I release the restriction of CISCO2811C/K9? 10M optical fiber, Speed limit of 125kb / s, made by last network administrator, how can I release the restriction? Please tell me the detail, thanks! Cisco configuration： CISCO2811C/K9 ! ! ! ! ! ! ! interface FastEthernet0/0 description WANpork ip address x.x.x.x 255.255.255.248 ip access-group 110 in no ip proxy-arp ip verify unicast reverse-path ip nat outside ip virtual-reassembly duplex auto speed auto ! interface FastEthernet0/1 description LANpork ip address 192.168.x.x 255.255.255.0 ip access-group 101 in no ip proxy-arp ip verify unicast reverse-path ip nat inside ip virtual-reassembly rate-limit output 1000000 1000000 1000000 conform-action transmit exceed-action drop duplex auto speed auto !
Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.
Match the following routing protocols with their routing algorithm. A. OSPF 1. Distance Vector B. IGRP 2. Link-State C. RIP D. IS-IS E. NLSP F. RTMP G. AURP H. BGP
It is not necessary to build an entire network to prove your network design. A. True B. False
Client traffic is being bridged trough LAN interfaces on two WLCs.Which roaming option will Keep them on the same IP Subnet ?
The following are the four steps in establishing an X.25 virtual circuit. Place them in the correct order. A. The PSE (Packet Switch Exchange) passes the packet to the next remote DCE B. The local DCE packet binder sends packet to the closest PSE (Packet Switch Exchange) C. The source DTE sends packet to the local DCE D. The remote DCE examines the packet header of destination DTE
5. Which Two Settings must be configured in order to use the GUI to configure Call Admission Control with voice Applications
Which tools help to characterize a network? A. Sniffer B. CiscoWorks 2000 C. Netsys D. All of the above
Which address is updated at each hop in the path in path switching?
CCNA 
