Interested to Buy Any Domain ? << Click Here >> for more details...
Which layer is responsible for framing?
A.) Application
B.) Data Link
C.) Physical
D.) Network
E.) Transport
- 3 Answers
- 11422 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: B
The Data link layer performs the following: Responsible for
physically
passing data from one node to another. Translates messages
from the
upper layers into data frames and adds customized headers
containing the
Hardware destination and source address.
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / jp
actuall data changes in each Layers -
Application data
Presentation data
Session data
Transport Segment
Netword packet
Datalink Frams
Physical Bit
so the correct Answer is B
| Is This Answer Correct ? | 2 Yes | 0 No |
Cisco routers use wildcard masking to identify how to check or ignore corresponding IP address bits. What does setting a wildcard mask bit to 0 cause the router to do? A. It tells the router to check the corresponding bit value. B. It tells the router to ignore the corresponding bit value. C. It tells the router to check its alternate routing list. D. It tells the router to use its primary routing list.
How many potions of ip?
Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary port B.) ROM port C.) Management port D.) Console port
What is the difference between full duplex and half duplex?
Which layer of the 7 layer model is responsible for representing the application information between 2 different OS's? For example, converting ASCII to EBCIDIC. A.) Transport B.) Application C.) Physical D.) Session E.) Presentation F.) Network
Identify the purpose of ARP? A.) Avoiding routing loops B.) Determining a workstation's IP address C.) Sending a directed broadcast D.) Determining a workstation's MAC address
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch
Why twist in twisted pairs?
Which layer is responsible for providing mechanisms for multiplexing upper-layer application, session establishment, and tear down of virtual circuits? A.) Session B.) Network C.) Physical D.) Transport E.) Application F.) Presentation
PLACE YOURS QUESTION HERE I ALSWYS BE HERE FROM 9 AM TO 6PM SO U CAN FIND YOUR ANSWER QUICKLY.IF I KNOW THEN ? JJIITTEENNDDEERRAA SSIINNHHAA
Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it
What information can you get from CDP info: (choose all that apply) A.) Hardware platform B.) One address per protocol C.) Software platform D.) Hostname E.) The same info as show version F.) Incoming/outgoing port
CCNA 
