Which three pieces of CDP information about neighbours routers are displayed on

Which three pieces of CDP information about neighbours
routers are displayed on your console terminal? (Choose three)

A. neighbours router a host name

B. the neighbours router a hardware platform

C. up to one address for each protocol supported

D. up to two addresses for each protocol supported

Question Posted / guest

1 Answers
4851 Views
I also Faced
E-Mail Answers

Which three pieces of CDP information about neighbours routers are displayed on your console termin..

Answer / guest

Answer: A, B, C

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More CCNA Interview Questions

Which dynamic type draw back is, if single link down, it removes its routing table?

0 Answers

You just entered the following command_Router(config#) line console 0 Which operation is most likely to follow? A. Confound terminal type B. enter protocol parameters for a serial line C. create a password on the console terminal line D. establish a terminal type 4 connection to a remote host E. change from configuration mode to console privileged mode

10 Answers Intel, Quark, Wipro,

Difference between routed and routing protocols not difference between protocol between those.

3 Answers HCL, TCS,

What is the difference between cross cable and straight cable?

0 Answers

What is the draw back of eigrp protocol?

0 Answers

What is size of ipv4 mac address?

0 Answers

The -- terminal no editing -- command will perform what function? A.) Edit the contents of NVRAM B.) Allows access to the terminal port C.) Stops the advanced editing feature D.) Enable password functions

2 Answers

Which command should you use to create an IP standard access list? A. access-list standard 172.16.4.13 B. access-list 1 deny 172.16.4.13 0.0.0.0 C. access-list 100 deny 172.16.4.13 0.0.0.0 D. access-list 198 deny 172.16.4.13 255.255.255.255

3 Answers

What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.

1 Answers

An autonomous system can only exist if all routers in that system meet which criteria? A. interconnected B. run the same routing protocol C. assigned same autonomous system number D. run IGRP only E. run RIP only

1 Answers

What is the administrative distance for RIP? A.) 100 B.) 90 C.) 120 D.) 110

8 Answers

what is the network address?

2 Answers HCL,

For more CCNA Interview Questions Click Here