Which two statements accurately define IP addressing rules?
(Choose two)
A. IP multicast addresses start with 240
B. A host Carbon of all 1 a indicates a network broadcast
C. The value of zero (0) in the host Carbon means all hosts
on the network
D. IP addresses are four octets long and contain a network
Carbon and a host Carbon
- 2 Answers
- 7448 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / s.m.feroz ahmed
Hi,
D. IP addresses are four octets long and contain a network
Carbon and a host Carbon is the right answer.
here 4 octets each octet has 4 bits and the scenario is
0 0 0 0 are 4 octets assume each octet is divided into 8
bits and these 4 octets together consists of 64 bits.
| Is This Answer Correct ? | 1 Yes | 0 No |
I received a call from client that network is down. We have 100 or 1000 of switches and routers so how could we find the client switch and its port number? and useful commands to find this ?
What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC
Which protocols are link states?
10. Which STP state populates the MAC address table but doesn't forward data frames? A. Blocking B. Listening C. Learning D. Forwarding
What is the Difference between Switch and Bridge?
There is a process in Frame-Relay where LMI resolves an IP address from a DLCI number. What is this called? A.) arp B.) inverse arp C.) rarp D.) automap E.) reverse arp F.) arp
Which network mask should you place on a Class C address to accommodate a user requirement of two subnetworks with a maxximum of 35 hosts on each networks A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248
What is DHCP stand for?
What is the difference between DTE & DCE???
What does the IPX maximum path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)
Which command will display the IPX routing table? A.) show routes B.) show routes ipx C.) show routes protocol=ipx D.) show ipx E.) show ipx route
HI ALL , wanted to know if the rstp protocol.. rapid spanning tree protocol .. is imp to study with ccna's point of view or study of STP will be enough.. in some books rstp is nt given like todd lamle however in icnd2 its explained in detail.. please suggest asap .. thanks ..
CCNA 
