Identify 2 PPP characteristics?
A.) Is proprietary to Cisco
B.) Supports authentication
C.) Support compression
D.) Run on a multi-access network
Answers were Sorted based on User's Feedback
Answer / guest
Answer: B C
PPP supports authentication; PAP and CHAP. It also supports
compression;
Stacker and Predictor.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / sajid ali
B,C because PPP features are
1-Authentication
2-Compression
3-Error Detection
| Is This Answer Correct ? | 1 Yes | 0 No |
How can you measure out exactly 4 litres of water from a tap using a 3 litre and a 5 litre bucket?
Given the configuration example<HR> <B>interface ethernet0 ipx network 4a ipx access group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network 5c access list 800 permit 3d 4a</B><HR> Which two actions result from implementing this configuration? (Choose two) A. IPX network 5c will not receive any traffic B. Traffic from network 3d for network 4a will be forwarded out e0 C. Traffic from network 4a for network 3d will be forwarded out e0 D. Traffic from network 3d destined for network 4a will be forwarded out e2 E. The access list is applied to an outgoing interface and filters outbound traffic
how to shutdown a Cisco router from command prompt?
11 Answers Atlas Systems, HCL,
On an ISDN BRI interface, the control channel is the 'D' channel. What is the rate of this channel? A.) 64 Kbps B.) 1.544 Mbps C.) 128 Kbps D.) 2.048 Mbps E.) 16 Kbps
The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.
When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30
You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router
What is the difference between dynamic ip and static ip addressing?
Dear Mr.Shahin thank you very much for your advise i realy thanks full to you. Best of luck
You have a Class B network address divided into 30 subnets. You will add 25 new subnets within the next year. You need 600 host IDs for each subnet. Which subnet mask should you use? A.) 255.254.0.0 B.) 255.192.0.0 C.) 255.255.252.0 D.) 255.255.248 0
Which command will show you if you have a DTE or DCE cable connected to an interface?
What are the steps of conversion for data encapsulation?