1. How many nodes you are using project?
2. What is configuration file?
3. What is modules partition? How it is work in
project?
4. What is Environment Variable? How it is use?
5. What is sequence?
6. How do you execute parallel jobs in projects?
7. If you run a job in job sequencer individually
without any comments?
8. How many jobs did in your project?
9. How to schedule the job in Data stage 7.5 X2?
10. If you have 10 jobs in PX2, shall you run all jobs
at a time?
11. I have 5 jobs (1-5), I connect with each other, but
I want to run from 3-5 only how?
12. What is same partition?
13. If you have 40GB hard disk in I have 30GB data how
I configure the nodes for partition?
14. Did you write any code for Data stage project?
15. Did you write any code for parallel job execution
in your project?
16. Will you schedule all jobs at a time?
No Answer is Posted For this Question
Be the First to Post Answer
Where does the LGWR process writes information?
Which database is good for large data?
How do you call a stored procedure from jdbc?
Explain ddl interpreter?
How easy is netlib to use?
What does a COMMIT statement do to a CURSOR?
What you know in mapping of erd to dfd?
Explain data independence?
what is postback trigger?
What is database partition key?
What are database functions?
if monday take full backup and tuesday it was cumulative backup and wednesday we taken incremental backup, thursday some disaster happen then what type of recovery and how it will take?