Answer / guest

Answer: D

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

2 Answers  

---

Identify 3 characteristics of a MAC address? A.) Burned into the NIC B.) 48 bits long C.) Length is 32 bits D.) Used to identify a host device E.) Contains a network portion and a host portion

2 Answers  

---

Identify 3 characteristics of a MAC address? A.) Burned into the NIC B.) 48 bits long C.) Length is 32 bits D.) Used to deliver the frame to the end device E.) Contains a network portion and a host portion

2 Answers  

---

Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router

3 Answers  

---

What will you do if ur IOS in coorrupt/deleted/Wrong Type/No IOS image ?

3 Answers   Allied Group,

---

What is the default size of frame?

0 Answers  

---

Which can be logged by IPX extended access lists? A.) source address B.) protocol C.) source socket D.) access list number E.) destination socket F.) destination address

1 Answers  

---

Identify the default IPX serial encapsulation? A.) Novell-Ether B.) SDLC C.) SNAP D.) HDLC

1 Answers  

---

Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router

1 Answers  

---

What key do you use to view the last command? A.) Ctrl+X B.) Ctrl+Z C.) Ctrl+E D.) Ctrl+P

2 Answers  

---

What are the three phases of PPP session establishment? A. Link establishment phase B. Authentication phase C. Network layer protocol phase D. Handshake phase E. Dial-in phase

2 Answers  

---

Can you explain in a generic manner the packet of IPSec?

0 Answers   CCIE,

---