What is the correct command line syntax for configuring a
port on
a 7000 or 7500 series Cisco router with a VIP card?
A.) port
B.) port adapter/port
C.) You can't put a VIP card in a 7000 or 7500 router.
D.) slot/port-adapter/port
E.) slot/port
F.) slot
- 1 Answers
- 3676 Views
- I also Faced
- E-Mail Answers
How many collision domains are in switch?
Which ISDN specification deals with call Setup and Teardown? A.) Q-Series B.) J-Series C.) I- Series D.) C- Series E.) F-Series
How network gateway is different from routers?
Which of the following statements are true? A.) Store and forward switching creates variable latency through the switch B.) Cut through switching creates variables latency through the switch C.) Cut through switching works at wire speed D.) Store and forward switching works at wire speed
hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
Identify the 3 pieces of hardware you would not install to prevent broadcasts? A.) Switch B.) Repeater C.) Bridge D.) Router
What is the protocol number for UDP? A.) 6 B.) 17 C.) 25 D.) 21
What is difference between rip and ripv2?
Which 3 statements describe default encapsulation and LMI type configuration? A.) There are only four encapsulations and 3 LMI type options B.) The LMI type config term options C.) In release 11.3 the LMI type is autosensed D.) The default LMI is Cisco E.) IETF encap must be configured unless the connecting routers are both cisco
Which ISDN protocol prefix specifies switching and signaling? A.) I B.) E C.) Q D.) S
b Which protocol for PPP LCP (Link Control Protocol) performs a challenge handshake? A. CHAP B. PAP C. UDP D. IPX
which is following route will be used to froword data in a situation where a routing table tables contains static ,RIP,IGRP routes destined to the same network with each set to its default administrative distance
CCNA 
