Interested to Buy Any Domain ? << Click Here >> for more details...
How does the cut-through switching technique work?
A.) By using broadcast address as source addresses
B.) The switch waits only for the header to be received
before it checks
the destination address and starts forwarding the packets
C.) The LAN switch copies the entire frame into its onboard
buffers and
then looks up the destination address in its forwarding, or
switching,
table and determines the outgoing interface
D.) By using a Class I repeater in a collision domain
- 1 Answers
- 4268 Views
- I also Faced
- E-Mail Answers
LMI operates between the Frame Switch and what other device? A.) CPE device B.) Another Frame Switch C.) X.25 switch D.) Novell File Server
What is the size of ipv4?
What is the key advantage of using switches?
A routing table contains static, RIP, and EIGRP routes for the same destination network. Which route would normally be used to forward data?
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI
Why do you use ‘service password encryption’?
Identify 2 characteristics of PPP? A.) Uses LLC to establish the link B.) Default serial encapsulation C.) Support multiple layer 3 protocols D.) Offers two types of authentication; PAP and CHAP
A router blocks ___________ Broadcasts Unicasts All packets Nothing
The Physical layer works with which of the following: A.) Segments B.) Datagrams C.) Packets D.) Bits E.) Frames
What is true when creating static route? A.) The mask parameter is optional B.) The administrative distance is required C.) The gateway parameter is required D.) The administrative distance is optional
Which statement about half duplex Ethernet operations is true? A. With half duplex transmission frames feed into a single cable in one direction at a time. B. Half duplex transmission between stations is achieved by using point to point Ethernet and Fast Ethernet connections C. Half duplex transmission between stations is achieved by using point to munificent Ethernet and Fast Ethernet connections D. Half duplex Ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end of the connection
What is the command for change serial cost?
CCNA 
