Interested to Buy Any Domain ? << Click Here >> for more details...
Which layer is responsible for framing?
A.) Application
B.) Data Link
C.) Physical
D.) Network
E.) Transport
- 2 Answers
- 6045 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number
Hi Jitendera, I continuously read your answers which is more knowlegable than books... Q.I am facing some problems in subnetting.can you plzz explain the subnetting process.. will be remain thankful
how will configure Nat
Assuming no subnetting, which two pieces of information can be derived from the IP address 144.132.25.10? (Choose two) A. It is a Class C address B. It is a Class B address C. The network address is 144.0.0.0 D. The network address is 144.132.25.0 E. The host spoon of the address is 25.10
IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing
Hi Jitendera, I need ur suggestion. I completed my CCNA certification & also hving some sort of real time experience. Now i m planning to do CCNP. Little bit confusion is that whether it wud be better for me to go for CCNP ya CCNA (Security). As off my goal is to reach CCIE (Security & Switching/Routing). So tell me some solution of my confusion yaar..!!! Thanx & Regards Shahin..
raid can be used in? 1 NT 2 Netware 3 all of above mine answer -NT
A big part of the overhead on a network is broadcasts. You divide a large number of hosts into smaller individual networks and separate them with the proper device According to proper networking terminology you have created separate _______________________, User Domains Broadcast Domains Collision Areas Broadcast Areas
Identify the purpose of the following command 'ip route 192.168.100.0 255.255.255.0 10.1.0.1' A.) Enabling a dynamic routing protocol B.) Creating a static route to the 10.1.0.0 network C.) Teaches the router about the distant network 192.168.100.0 and how it can be reached via 10.1.0.1 D.) Assigning the IP address 192.168.100.0 to an interface
What port does rip use?
Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport
which is following route will be used to froword data in a situation where a routing table tables contains static ,RIP,IGRP routes destined to the same network with each set to its default administrative distance
CCNA 
