Interested to Buy Any Domain ? << Click Here >> for more details...
Which layer is responsible for determining if sufficient
resources
for the intended communication exists?
A.) Application
B.) Network
C.) Session
D.) Presentation
E.) Transport
- 1 Answers
- 4325 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A
The Application layer is responsible for determining if
sufficient
resources for the intended communication exists.
| Is This Answer Correct ? | 1 Yes | 0 No |
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. mac-address 0005.1b00.5b58
What are the two types of transmission technology available in ccna?
can we measure how much a host exact bandwidth using by a network cable which is communicating over the network? options: 1- via Router 2- Switch, 3- other device... if yes.. then how ( with every option)
The following commands were entered at the command prompt of a Cisco router. What do they accomplish? access-list 1000 deny 9e.1234.5678.1212 4 access-list 1000 permit -1 interface ethernet 0 ipx network 9e interface ethernet 1 ipx network 4a interface serial 0 ipx network 1 ipx output-sap-filter 1000 A. File server advertisements from server 9e.1234.5678.1212 will not be forwarded on interface S0. B. All other SAP services, other than file server, from any source will be forwarded on S0. C. All other SAP services, other than print server, from any source will be forwarded on S0. D. Print server advertisements from server 9e.1234.5678.1212 will not be forwarded on interface S0.
What is the terminal emulation?
What is CRC and which layer it use?
What are the steps of conversion for data encapsulation?
On which layer does L2F, PPTP and L2TP operate?
What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network
What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds
Which command will display the encapsulation type on interface serial 0? A.) show interface s0 B.) show all C.) show int s0 encap D.) show encap s0 E.) show encap
When a Distance Vector routing protocol detects that a connected network has gone down, it sends out a special routing update packet, telling all directly connected routers that the distance to the dead network is infinity. This is an example of which routing technology? A.) ICMP. B.) Only Link State routing protocols have this intelligence. C.) Triggered updates. D.) Garrison-4. E.) Split Horizon. F.) Poison Reverse.
CCNA 
