Answer / guest

Answer: D

Ethernet_II has a Type field to identify the upper-layer
protocol. This

is best seen by capturing packets with a sniffer and
examining the packet.

Answer / kulanand rana

Ethernet_II has a Type field to identify the upper-layer
protocol. This

is best seen by capturing packets with a sniffer and
examining the packet.

We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?

6 Answers   Wipro,

---

Which type of Ethernet framing is used for TCP/IP and AppleTalk? A. Ethernet 802.3 B. Ethernet 802.2 C. Ethernet II D. Ethernet SNAP

1 Answers   Wipro,

---

Cisco's implementation of ISDN BRI has multi protocol support, SNMP MIB support, and what other features? A.) Call waiting B.) Compression C.) ADSL D.) 1.544 Mbps E.) Call screening F.) Negative 'G' support

1 Answers  

---

What will you do if ur IOS in coorrupt/deleted/Wrong Type/No IOS image ?

3 Answers   Allied Group,

---

Which three basic switch functions increase available bandwidth on the networks? (Choose three) A. loop avoidance B. address learning C. hop count limiting D. broadcast filtering E. packet forward/filtering

3 Answers  

---

Which show underrate serial 1 status statement indicates that the shutdown command was issued on that interface? A. Serial 1 is up line protocol is up B. Serial 1 is up line protocol is down C. Serial 1 is down line protocol is down D. Serial 1 is administratively down the line protocol is down

2 Answers   Pioneer Labs,

---

What is the difference between bus topology and hub?

0 Answers  

---

Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

3 Answers  

---

'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers

2 Answers  

---

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

Tell me how many hop counts are by default and how much you can increase in eigrp protocol?

0 Answers  

---

plz send me cisco contact no india?

0 Answers   3i Infotech, Cisco,

---