Interested to Buy Any Domain ? << Click Here >> for more details...
IP RIP routing is conferred on a router but not all
interfaces attach to RIP networks. What should you use to
prevent all RIP routing updates from being sent through
selecedc interfaces without using access lists?
A. passive route
B. default routes
C. passive interface
D. route update filtering
- 2 Answers
- 6789 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
On which mode we give debug command?
b Which protocol for PPP LCP (Link Control Protocol) performs a challenge handshake? A. CHAP B. PAP C. UDP D. IPX
What cable called v.35?
Explain how many types of router?
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physcial interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
X.25 is characterized by layer 2 identifiers, and what else? A.) Virtual Lan's B.) Session Layer C.) Transport Layer D.) Routing Updates E.) PVC's
You receive "input filter list is 800 and output filter list is 801" as part of the output from a show interfaces command. What kind of traffic are you filtering? A. IPX/SPX B. TCP/IP C. LocalTalk D. DDR
Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction
what is the reason for creating vlans
What is a characteristic of Store and Forward switches? A.) They forward the frame before it is completely read. B.) They work at wire speed. C.) They are the same a Cut-Through switching. D.) They read the entire frame and check CRC before forwarding. E.) They decrease latency.
You create the following standard access-list access-list 1 deny 1.1.1.1 access-list 1 deny 2.2.2.2 int e0 ip access-group 1 in Which of the following statements are true, with regard to traffic flowing into E0? A.) This will stop IP packets with a source address of 1.1.1.1 only. B.) This will stop all IP packets. C.) This is an invalid configuration. D.) This will stop no IP packets. E.) This will stop IP packets with a source address of 2.2.2.2 only. F.) This will stop IP packets with a source address of 1.1.1.1 and 2.2.2.2.
Mention what BOOTP is?
CCNA 
