Answer / guest

Answer: B

Which command would configure Interface E0 with an IP address of 12.23.4.5 using a Subnet mask of 255.255.255.0 ? A.) ip address 12.23.4.5 255.255.255.0 B.) ip address 12.23.4.5 /24 C.) ip address 12.23.4.5 mask 255.255.255.0 D.) ip address 12.23.4.5 mask ff:ff:ff:0 E.) that is an invalid mask for a class 'A' address

3 Answers   Wipro,

---

In distance-vector routing, there is a problem known as the 'count to infinity' problem. What is the most direct solution to this? A.) Defining a Maximum. B.) You can not solve the 'count to infinity' problem with a distance vector protocol. C.) Poison Reverse. D.) Triggered Updates. E.) Split Horizon.

2 Answers  

---

You have just issued the erase startup-config Command and reloaded your router. In which mode will your router be when you react? A. setup B. startup C. user EXEC D. userd privileged E. global configuration

3 Answers  

---

Identify the command that configures the bandwidth to 56K? A.) Router(config-if)# bandwidth 56000 B.) Router(config-if)# bandwidth 56k C.) Router(config)# bandwidth 56 D.) Router(config-if)# bandwidth 56

1 Answers  

---

Which is the protocol using multiple tcp/ip connections? SLIP or PPP

2 Answers   Sutherland,

---

What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC

2 Answers  

---

Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols

1 Answers  

---

hello i am new to this, i need to know how will i complete a basic scenario that ask the required number of networks that is 80 and the minimum number of host that is 3000 and the network address is 10.0.0.0 and i need to need how to compute to get the answer on what is the subnet mask.

3 Answers   Kaplan,

---

What is the protocol number for TCP? A.) 80 B.) 21 C.) 11 D.) 6

1 Answers  

---

When you issue the command show version your router returns "Configuration register is 0x0101" From where does the router boot? A. ROM B. NVRAM C. Flash D. a TFTP server

3 Answers  

---

Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

2 Answers  

---

You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet

1 Answers  

---