Answer / guest

Answer: A C E

Identify 3 characteristics of a MAC address? A.) Burned into the NIC B.) 48 bits long C.) Length is 32 bits D.) Used to deliver the frame to the end device E.) Contains a network portion and a host portion

2 Answers  

---

What is the difference between arp and rarp?

0 Answers  

---

How many networks route update does a router recieves in RIP at once ?

3 Answers   ComNet,

---

Which two steps are part of the process of creating Frame Relay subinterfaces on a point to point connection? (Choose two) A. configure the router to forward all broadcast packets B. remove any network address assigned to the physical interface C. configure the local data link connection identifier (DICI) for the subinterfaces D. cartoon the total committed information rate (CIP) available among the subinterfaces

1 Answers  

---

Which Distance Vector characteristic can help to speed up convergence? A.) Triggered Updates. B.) Split Horizon. C.) Poison Reverse. D.) Hold Down timers. E.) Inverse ARP.

1 Answers  

---

Identify 1 characteristic of RARP? A.) MAC to IP address translation B.) Connectionless delivery of packets C.) Can be used to initiate remote O/S load sequence D.) Generates error and control messages

5 Answers  

---

How Bridge Protocol Data Unit detect looping in Network? How Bridge Protocol Data Unit work? explain?

1 Answers  

---

Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department

1 Answers  

---

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

2 Answers  

---

You are a network administrator and have been assigned the IP address of 201.222.5.0. You need to have 20 subnets with 5 hosts per subnet. What subnet mask will you use? A. 255.255.255.248 B. 255.255.255.128 C. 255.255.255.192 D. 255.255.255.240

2 Answers  

---

Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.

1 Answers  

---

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

2 Answers  

---