From Enable mode, a user types the letter 'C' and presses enter.
There is more than 1 command that starts with 'C'. What
message would
the router return?
A.) Nothing would be returned, the command is simply ignored.
B.) unknown command
C.) ambiguous command.
D.) Copy to?
E.) Configured console from console.
Hi Guys I am facing one problem while configuring PAP over Point to Point links. Configuration scenario is like this. ROUTER 1: (Hostname – R1) R1(config)#username R2 password CCNA2 R1(config)#interface serial 1/1 R1(config-if)ip address 10.0.0.1 255.0.0.0 R1(config-if)#lock rate 64000 R1(config-if)#encapsulation ppp R1(config-if)#ppp authentication pap R1(config-if)#ppp pap sent –username R1 password CCNA1 R1(config-if)#no shutdown ROUTER 2: (Hostname – R2) R2(config)#usename R1 password CCNA1 R2(config)#interface serial 1/1 R2(config-if)#ip address 10.0.0.2 255.0.0.0 R2(config-if)#encapsulation ppp R2(config-if)# ppp authentication pap R2(config-if)# ppp pap sent –username R2 password CCNA2 R2(config-if)#no shutdown Now problem is that, after configure the command “ppp authentication pap” the “Line protocol” status goes down on each router. But when I disable this command using “no ppp authentication pap”, the “Line Protocol” status goes up. What could be the problem, can anyone explain it plzzz….!!! Thanks in Advance…!! Shahin..
How many voltage that passes through the ISDN?
4 Answers CTS, Swirl Infosystems,
Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route
Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay
What not a name of an ISP? A. MSN B. Comcast C. Verizon D. McDonalds
What is the function of DDR on Cisco routers? A. DDR is dial--on-demand routing. It provides a continuous LAN only connection. B. DDR is dial-on-demand routing. It provides routing for high volume traffic. C. DDR is dial--on-demand routing. It provides a continuous WAN connection. D. DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.
Given the command 'cl?', what will it display? A.) Syntax of the 'clock' command B.) Syntax of the 'clear' command C.) All commands that begin with 'cl' D.) All commands that begin with 'c'
What is the command for change serial cost?
Name the different types of networks
Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco
MIDI and MPEG are examples of what layer of the OSI seven layer model? A.) Session B.) Network C.) Datalink D.) Transport E.) Application F.) Presentation
NetWare IPX addressing uses a network number and a node number. Which statements are true? A. The network address is administratively assigned and can be up to 16 hexadecimal digits long. B. The node address is always administratively assigned. C. The node address is usually the MAC address. D. If the MAC address is used as the node address, then IPX eliminates the use of ARP.