You want to set the console password to ralph. What would be the

first command you need to execute from global configuration
mode?

A.) line console 0

B.) enable password ralph

C.) login password ralph

D.) set password= ralph

E.) password ralph

F.) login Ralph



You want to set the console password to ralph. What would be the first command you need to execut..

Answer / guest

Answer: A

Is This Answer Correct ?    3 Yes 0 No

Post New Answer

More CCNA Interview Questions

Which reserve port no http use?

0 Answers  


What is the command to allow you to type Tokyo instead of the IP address 172.16.30.1 to access a router named Tokyo? A.) config t, ip host Tokyo 172.16.30.1 B.) config t, ip hostname Tokyo 172.16.30.1 C.) config t, hostname Tokyo 172.16.30.1 D.) config t, ip hostname 172.16.30.1 Tokyo

2 Answers  


As a system administrator, you want to debug igrp but are worried that the "debug IP igrp transaction" command will flood the console. What is the command that you should use? A. debug IP igrp event B. debug IP igrp-events C. debug IP igrp summary D. debug IP igrp events

1 Answers  


What is default size of hello packets in ospf?

0 Answers  


Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route

1 Answers  


Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash

2 Answers  


Identify the correct IGRP configuration? A.) Router# router igrp 100 Router# network 10.0.0.0 B.) Router(config)# router igrp 100 Router(config-router)# network 10.0.0.0 C.) Router(config)# router igrp Router(config-router)# network 10.0.0.0

1 Answers  


For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix

1 Answers  


Which of the following are valid WAN terms? A.) DTE B.) DCE C.) Demarc D.) CPE

3 Answers   IBM,


let there are three switch and there are 3 ree valn craed on each switch that is vlan 2 on first switch valn 3 on 2nd switch and vlan 4 is cretaed on switch 3 i have implemnted intervlan routin through ciso switchses. the router is conected through its fa0/1 port by one switch and and the two switch are trunked with each other now question is that we want to comuniacte betwwen vlan but does alse want that only vlan 2 is allow to access internet (ISP)which is conected through s0 interface of router.and no any vlan can access that internet.what should be solution.

1 Answers  


Can yo define LNS

0 Answers   CCIE,


Can you explain voluntary and compulsory tunnels?

0 Answers   CCIE,


Categories