The default routing protocol for IPX is IPX RIP. How do you view
the routing updates sent and received by the router?
A.) debug ipx routing
B.) debug ipx routing activity
C.) debug rip
D.) show ipx routing
E.) sh ipx
F.) debug ipx rip
- 4 Answers
- 5399 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / fred c
To view routing updates sent and received by the router,
the command to use is - debug ipx rip
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / ajmal abdul gafoor
The default routing protocol for IPX is:
> sh ipx
| Is This Answer Correct ? | 0 Yes | 0 No |
What is Route Poisoning?
Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.
What are the Timer of RIP, IGRP, EIGRP and OSPF Routing Protocol?
Which three devices can be used to convert the user data from the DTE into a form acceptable to the WAN service's facility? A. Modem B. CSU/DSU C. TA/NT1 D. CO E. SS7
what is meant by domain ? what is mean by DNS?
Define bandwidth?
Which command should you use to create an IP standard access list? A. access-list standard 172.16.4.13 B. access-list 1 deny 172.16.4.13 0.0.0.0 C. access-list 100 deny 172.16.4.13 0.0.0.0 D. access-list 198 deny 172.16.4.13 255.255.255.255
Identify the 3 kinds of routes IGRP advertises? A.) Interior B.) Dynamic C.) System D.) Exterior
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
How does a web page works though each layers ?
How many potions of ip?
On which layer does L2F, PPTP and L2TP operate?
CCNA 
