Why do we have a Layered Model?
1) It reduces complexity
2) Allows for a standardized interface
3) Facilitates modular engineering
4) Ensures interoperable technology
5) Accelerates evolution
6) Simplifies teaching and learning
- 1 Answers
- 3495 Views
- I also Faced
- E-Mail Answers
what is telnet,ssh?? what is the perpose of this? wer r this configured and how to configured??
what are two security appliances that can be installed a network
Which commands would assign and enable IPX on an interface ? A.) enable netware B.) enable novell-ether C.) router#(config)ipx routing D.) You must first enable IPX globally and then assign the network number to the interface . E.) enable ipx F.) router#(config-if)ipx network 4a
Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecting to non-Cisco equipment C.) You must use Q.933a encapsulation if connecting to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment
To monitor ipx traffic on a network, what command would you use? A. debug ipx transaction B. show ipx traffic C. show ipx events D. display ipx traffic
Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25
EIGRP send query reply & Acknowledgment on which address ?
What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN
Hi all of you, Actually this is interview qe? but i did,t do explain it completely so please give reply recently and completly Ans, what is sub-interface and inter-vlan ? And How to implement it on cisco router & switches and also which series router switches supported please write..........
what is the high order bit in class a 1 11 110 10 mine answer 1
Routers that have Flash memory typically have a ore loaded copy of place IOS software. Which command should you use to make a backup copy of the software image onto a given network server? A. copy flash tftp B. save copy to tftp C. write backup tftp D. write, backup -server-name- E. copy backup to -server-name-
What command would you use to find out the names of Novell servers on a network? A. show ipx servers B. show ipx hosts C. show ipx sap D. show ipx nodes.
CCNA 
