Answer / guest

Answer: C

Identify 3 characteristics of a connection oriented protocol? A.) Path determination B.) Flow control C.) Acknowledgements D.) Uses hop count as metric E.) 3 way handshake

2 Answers  

---

why we assingn the wild card mask in the use of ospf and access list.

6 Answers   IBM,

---

How do you go to privileged mode? How do you switch back to user mode?

0 Answers  

---

Identify 3 IP routing protocols? A.) RIP B.) AURP C.) OSPF D.) IGRP E.) ARP F.) ICMP

2 Answers  

---

We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?

6 Answers   Wipro,

---

Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active

1 Answers  

---

Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash ftp D. copy tftp flash

2 Answers  

---

The Internet Protocol (IP) occurs at what layer of the seven layer model? A.) Physical B.) Presentation C.) Network D.) Datalink E.) Session F.) Transport

2 Answers  

---

What is fcs?

0 Answers  

---

FastEthernet compares to 10baseT Ethernet in which of the following ways

1 Answers  

---

Which three are typical operational phases in a basic connection oriented network service? A. call setup B. data transfer C. load balancing D. call termination E. caller ID F. call prionflication G. data segmentation H. data and momma I. data link identification J. callering book

1 Answers  

---

What is the default switching method for the Cisco 5000 series? A.) Cut-through B.) Store-and-splice C.) Latency D.) Store-and-forward

1 Answers  

---