Answer / guest

Answer: C

Answer / c

c

Identify the length of an IPX address and it's components? A.) 80 bits, 48 bits network and 32 bits node B.) 32 bits, 16 bits network and 16 bits node C.) None of the above D.) 80 bits, 32 bits network and 48 bits node

1 Answers  

---

What is the update period for rip?

0 Answers  

---

How we ping ICMP a NIC with a correct IP address but with wrong MAC address Do all NIC's can run inpromiscuous mode

3 Answers   Cisco, HCL,

---

Your PC has been configured with IP Address 192.168.3.25 and a subnet mask of 255.255.255.0. Which of the following IP Addresses is a valid default gateway address for your PC? 192.168.3.0 255.255.255.0 192.168.3.2 255.255.255.0 192.168.3.25 255.255.255.0 192.168.4.1 255.255.255.255

2 Answers  

---

Which protocol resolves an IP address to a MAC address? A.) DHCP B.) RARP C.) ARP D.) NBP E.) DNS

3 Answers  

---

As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.

1 Answers  

---

Which type of updates eigrp protocol do?

0 Answers  

---

Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into this category? Gateway Switch Router All of the above.

1 Answers   Sutherland,

---

why we use AS no. in IGRP and EIGRP?

2 Answers   HCL,

---

A routing table contains static, RIP, and EIGRP routes for the same destination network. Which route would normally be used to forward data?

15 Answers   TCS, Wipro,

---

Identify the command to configure ALL the default VTY ports? A.) Router(config)# line vty 0 4 B.) Router# line vty 0 4 C.) Router(config)# line vty D.) Router(config)# line vty 0

2 Answers  

---

What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000

1 Answers  

---