Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# i

Identify the command that specifies Serial 0 in slot 1?

A.) Router(config)# interface serial1/1

B.) Router(config)# interface serial1/0

C.) Router(config)# interface serial0.1

D.) Router(config)# interface serial0/1

Question Posted / guest

4 Answers
7917 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 ..

Answer / guest

Answer: B

Is This Answer Correct ?

8 Yes

0 No

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 ..

Answer / sachin

Is This Answer Correct ?

5 Yes

0 No

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 ..

Answer / robert

#interface serial slot/port.....
so hear 1 is slot and 0 is the port number connected.so

B.)Router(config)#interface serial1/0 is Answer.....

Is This Answer Correct ?

4 Yes

0 No

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 ..

Answer / haja bahurudeen m

Answer : B

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More CCNA Interview Questions

Identify 3 Fast Ethernet technologies? A.) 100 Base FastEther B.) 100 Base FX C.) 100 Base T4 D.) 100 Base TX

2 Answers

What is the difference between the communication and transmission?

0 Answers

Name the 2 protocols are in wan technology?

0 Answers

Which network mask should you place on a Class C address to accommodate a user requirement for five networks with a maximum of 17 hosts on each networks A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248

7 Answers

Hi my company network is creating loop and network performence is big slow and also all pc don,t get dhcp ip so pls let me know what is happing in my network.

3 Answers

On an ISDN BRI interface, the control channel is the 'D' channel. What is the rate of this channel? A.) 64 Kbps B.) 1.544 Mbps C.) 128 Kbps D.) 2.048 Mbps E.) 16 Kbps

4 Answers

What is a L2F protocol?

1 Answers CCIE,

Eight stations connected to separate 10 Mobs pods on a Layer 2 switch will give each station how many Mobs of bandwidth? A. 1.25 B. 4 C. 16 D. 10 E. 80

1 Answers

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers Karrox,

what is distance vector protocol link state protocol and what is the diffrence between them

5 Answers Wipro,

In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physcial interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay

2 Answers

Identify the X.25 addressing standard? A.) X.121 B.) X.25a C.) ITU-1 D.) Q933a

1 Answers

For more CCNA Interview Questions Click Here