Answer / guest

Answer: C

Answer / sudeep

c

Identify the purpose of the following command 'ip route 192.168.100.0 255.255.255.0 10.1.0.1' A.) Enabling a dynamic routing protocol B.) Creating a static route to the 10.1.0.0 network C.) Teaches the router about the distant network 192.168.100.0 and how it can be reached via 10.1.0.1 D.) Assigining the IP address 192.168.100.0 to an interface

2 Answers  

---

Name the command we give on privilege mode for coming back to user execution mode?

0 Answers  

---

Identify 3 methods not used to prevent routing loops? A.) Holddown timers B.) Sequence numbers C.) Triggered updates D.) Split horizon E.) Area hierarchies F.) Order of router startup

2 Answers  

---

Can you explain PPTP (Point-to-Point Tunneling Protocol)?

1 Answers   CCIE,

---

Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay

1 Answers  

---

Which of the following statements are true? A.) Store and forward switching creates variable latency through the switch B.) Cut through switching creates variables latency through the switch C.) Cut through switching works at wire speed D.) Store and forward switching works at wire speed

2 Answers  

---

Which of the following are ways to provide login access to a router? A.) HTTP B.) Console C.) Telnet D.) Aux Port E.) SNMP F.) LLC

3 Answers  

---

Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface

2 Answers   Wipro,

---

How does L2TP process?

0 Answers   CCIE,

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

1 Answers   Cisco, HCL,

---

What is refresher?

0 Answers  

---

Which type of switching is considered to be 'wire speed?' A.) Cut-Through B.) Multiplexed C.) Inverted D.) Layer 4 E.) Store and Forward F.) Layer 3

2 Answers  

---