Identify the command mode necessary to enter the extended ping command? A.

Identify the command mode necessary to enter the extended ping

command?

A.) Router#

B.) Router>

C.) Router(config)#

D.) Router(ext-ping)#

Question Posted / guest

1 Answers
4831 Views
I also Faced
E-Mail Answers

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Rou..

Answer / guest

Answer: A

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More CCNA Interview Questions

What causes a triggered update to reset the router hold-down timer?

0 Answers

Which statement about an IP network is true? A. A broadcast source MAC address contains all zeros B. A MAC address is part of the physical layer of the OSI model C. MAC addresses are used by bridges to make forwarding decisions. IP address are used by routers. D. IP addresses allow a flat addressing scheme. MAC addresses use a hierarchical addressing scheme.

2 Answers

Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?

0 Answers

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1

3 Answers Cisco,

What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface

1 Answers

R1#sh ip nat translations Pro Inside global Inside local Outside local Outside global icmp 15.1.1.1:11 10.1.1.1:11 30.1.1.1:11 30.1.1.1:11 icmp 15.1.1.1:12 10.1.1.1:12 20.1.1.1:12 20.1.1.1:12 icmp 15.1.1.1:13 10.1.1.1:13 21.1.1.1:13 21.1.1.1:13 icmp 15.1.1.1:14 10.1.1.1:14 31.1.1.1:14 31.1.1.1:14 R1# So my question is that after every ip address [:] is used & some number. 15.1.1.1{:11}... what is this colon & number indicate. Can anyone tel me this..!!! Thanking you advance. Shahin

4 Answers

How does L2TP process?

0 Answers CCIE,

Which router component stores routing tables APP cache and packet buffers? A. ROM B. RAM C. AVRAM D. Flash memory

3 Answers

what is nat.types of nat

3 Answers

What is trigger rip and from which ios version it starts?

0 Answers

What is the default bandwidth of a serial connection? A.) 1200 baud B.) 1.544 Mbps (T1) C.) 10 Mbps D.) 96Kpbs

2 Answers

Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25

1 Answers

For more CCNA Interview Questions Click Here