Answer / guest

Answer: A

What command would you use to find out the names of Novell servers on a network? A. show ipx servers B. show ipx hosts C. show ipx sap D. show ipx nodes.

1 Answers  

---

what is subnet mask?

5 Answers   HCL,

---

Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe

1 Answers  

---

You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.

1 Answers  

---

Which command do you use to set the Privileged mode password to 'clearwater'? A.) set password=clearwater B.) enable privilege password clearwater C.) enable password clearwater D.) enable login clearwater E.) enable secret password clearwater F.) ebable clearwater

2 Answers  

---

---

Which peer authentication method and which ipsec mode is used to connect to the branch locations?

0 Answers  

---

What is difference between routing and routed protocols?

0 Answers  

---

Which OSI layer handles physical address, network topology? A.) Presentation B.) Physical C.) Transport D.) Application E.) Data-Link F.) Network

2 Answers  

---

Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM

1 Answers  

---

The CSMA/CD Ethernet IEEE committee is defined as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5

2 Answers  

---

What are the advantages of using switches?

0 Answers  

---

What is the difference between communication and transmission?

0 Answers  

---