Interested to Buy Any Domain ? << Click Here >> for more details...
In regards to the ISDN BRI standard, which channel is used for
control?
A.) B
B.) D
C.) E
D.) I
E.) Q
- 2 Answers
- 5591 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / m haja bahurudeen
Ans : B) D
D - Data Channel - 16 Kbps
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / guest
Answer: B
B is Bearer for Data (2 channels at 64kb each).
D is for Control (16kb).
| Is This Answer Correct ? | 0 Yes | 0 No |
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
What’s the default CDP holdtime in seconds for Cisco routers?
The PDU at the network layer is a ________ Packet Frame Segment Bit
Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay
In stead of 0.0.0.0 wild card mask what you can write after ip?
ccna syallabus and what is the mean by troubble shooting
what is router,bridges,hubs?
Which command enables directly connected network 199.55.72.0 to be used by RIP? A. Router(config router)# rip 199.55.0.0 B. Router(config router)# rip 199.55.72.0 C. Router(config router)# network 199.55.0.0 D. Router(config router)# network 199.55.72.0
Which type of updates eigrp protocol do?
intial information of packey occur on which layer application sessions physical mine answer physical
What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface
Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into this category? Gateway Switch Router All of the above.
CCNA 
