On an ISDN BRI interface, the control channel is the 'D'
channel.
What is the rate of this channel?
A.) 64 Kbps
B.) 1.544 Mbps
C.) 128 Kbps
D.) 2.048 Mbps
E.) 16 Kbps
- 4 Answers
- 6096 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: E
16K for the D channel (control)
64K for the two B channels (data)
| Is This Answer Correct ? | 6 Yes | 0 No |
Answer / m haja bahurudeen
Ans : E) 16 Kbps
ISDN BRI interface
2B (Barrier channel) - 2*64 Kbps
1D (Data channel) - 1*16 Kbps
| Is This Answer Correct ? | 1 Yes | 0 No |
As the system administrator, you type "ppp authentication chap pap secret". Which authentication method is used first in setting up a session? A. secret B. PAP C. CHAP D. PPP/SLIP
Which way of communication bus topology use?
Name the command we give for see routing table?
Identify the 3 characteristics of IPX RIP? A.) Distance vector B.) Does not support multiple paths C.) 60 second updates D.) Default encapsulation is SAP E.) Uses ticks and hop count as a metric
why we give clock rate to DCE and not to DTE what is the difference in the two.
What is wide-mouth frog?
Explain how many types of ends in wan?
What is the difference between RIP & RIPng???? Can anyone explain it..!!! Thank u in advance.
What information is provided by the local management interface (LMI)? A.) LMI encapsulation type B.) The current DLCI values C.) The status of virtual circuits D.) The global or local significance of the DLCI values
What are the differnt memory use in cisco router?
Which of the following is true? A. The default is to send debug output to the console screen. B. To view debug output from a telnet session, the "terminal monitor" command must be used C. If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command D. If the "no console loggin" command were configured, output would besent to a telnet session E. All of the above F. None of the above G. A, B, and C. H. A, C, D, and E.
As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.
CCNA 
