Answer / guest

through command ip we can control the protocol.

Answer / rohit

through command ip we can assign or change ip address on
both classful and classless. with these address routing
protocol can find the user.

What do you use to write documentation? Editor? Mail reader?

0 Answers  

---

Explain the network architecture?

0 Answers  

---

What does the receiving host do with packets when it is using a connection-oriented protocol ? a. acknowledges only the first and last packet, puts the packets in their proper order. b. acknowledges only the first and last packet, discards in any packet that have arrived out of sequence. c. acknowledges each packet and puts the packets in their proper order. d. acknowledges each packet and discards in any packet that have arrived out of order

1 Answers  

---

You are setting up a 100 Mbps network in a building, which is pre-wired. After testing you decided that the cabling is category 3 compliant. What do you do? a. Keep existing b. Change to category 5

1 Answers  

---

what is work of application layer and presentation layer

5 Answers  

---

what is the error we get if one of the disk is failed in raid1 how can i restore the data from another disk

2 Answers   Sify,

---

Which layer is responsible for determining if sufficient resources for the intended communication exists? * Application * Network * Session * Presentation * Transport

13 Answers   Cisco, Inflow Technologies, Infotech,

---

Which layer ensures messages reach their destination system via an optimal route (done by planning the route).

1 Answers  

---

Define lan?

0 Answers  

---

Which layer is responsible coordinating communications b/w segments ? a. physical b. data-link c. network d. session e. application

1 Answers  

---

if u hv bad sectore in ur hard disk then can u recover ur data from that bed sectore if yes , how?

0 Answers  

---

How to configure RAS in PIX 515E

1 Answers   Sysnet,

---