Answer / guest

Answer: C

These protocols deal with ISDN issues:

E - Specifies ISDN on the existing telephone network.

I - Specifies concepts, terminology, and services.

Q - Specifies switching and signalling.

As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.

1 Answers  

---

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

1 Answers  

---

What is the difference between an igp and an egp?

0 Answers  

---

I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?

4 Answers   IBM,

---

Identify the 2 characteristics regarding MAC addresses? A.) Contains a network portion and host portion B.) Always assigned by System Administrator C.) 48 bits long D.) Contains a vendor code and serial number

1 Answers  

---

Hi, Can any one please tell me the experience of their CCNA interview,and please tell me all the questions they asked in the interview. Many Thanks...

0 Answers   HCL,

---

what is leased line and if any issue occur what will u do thai is trouble shootin occurs let leased line is down

1 Answers   Aptron, Cisco, HCL, Volvo,

---

Which commands would assign and enable IPX on an interface ? A.) enable netware B.) enable novell-ether C.) router#(config)ipx routing D.) You must first enable IPX globally and then assign the network number to the interface . E.) enable ipx F.) router#(config-if)ipx network 4a

1 Answers  

---

What is formula of hold down time of eigrp protocol?

0 Answers  

---

Identify the command to display the IP host table? A.) show ip hostnames B.) show ip names C.) show hosts D.) show ip hosts

1 Answers  

---

Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

3 Answers  

---

Which layer is responsible for routing through an internetwork? A.) Physical B.) Session C.) Network D.) Transport E.) Application F.) Data Link

4 Answers  

---