Answer / guest

Answer: B

NVRAM contains the backup config. RAM is the dynamic memory
area, ROM

contains the boot strap code and Flash contains the IOS.

What is the IEEE specification for Spanning Tree Protocol? A.) 802.9 B.) 803.ud C.) 803 D.) 802.1d

1 Answers  

---

Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers  

---

Which type of routing you did in ccna?

0 Answers  

---

Which is the protocol using multiple tcp/ip connections? SLIP or PPP

2 Answers   Sutherland,

---

Hi Guys I am facing one problem while configuring PAP over Point to Point links. Configuration scenario is like this. ROUTER 1: (Hostname – R1) R1(config)#username R2 password CCNA2 R1(config)#interface serial 1/1 R1(config-if)ip address 10.0.0.1 255.0.0.0 R1(config-if)#lock rate 64000 R1(config-if)#encapsulation ppp R1(config-if)#ppp authentication pap R1(config-if)#ppp pap sent –username R1 password CCNA1 R1(config-if)#no shutdown ROUTER 2: (Hostname – R2) R2(config)#usename R1 password CCNA1 R2(config)#interface serial 1/1 R2(config-if)#ip address 10.0.0.2 255.0.0.0 R2(config-if)#encapsulation ppp R2(config-if)# ppp authentication pap R2(config-if)# ppp pap sent –username R2 password CCNA2 R2(config-if)#no shutdown Now problem is that, after configure the command “ppp authentication pap” the “Line protocol” status goes down on each router. But when I disable this command using “no ppp authentication pap”, the “Line Protocol” status goes up. What could be the problem, can anyone explain it plzzz….!!! Thanks in Advance…!! Shahin..

6 Answers  

---

Which protocol can do load balancing on unequal cost also?

0 Answers  

---

What is the name of best path in eigrp protocol?

0 Answers  

---

What does the acronym ARP stand for? A.) Address Resolution Phase B.) ARP Resolution Protocol C.) Address Resolution Protocol D.) Address Recall Protocol

2 Answers  

---

Which two statements are true? (Choose two) A. Ethernet 802.3 utilizes a half duplex method for data transfer B. In a 100 MBS point to point connection a full duplex connection can provide 400 Mbs of data transfer C. Ethernet switches can use the full duplex mode to connect multiple nodes on a single pod of a switch D. Full duplex Ethernet takes advantage of UTP using one pair for transmission and the other pair for reception

1 Answers  

---

what is the reason for creating vlans

4 Answers  

---

What are the netbios and netbeui?

0 Answers  

---

what is the difference between hdlc and ppp protocol

7 Answers   ASD Lab, HCL,

---