Answer / guest

Answer: A

how many vlan can be configured on a single switch

12 Answers   IBM, Sigma IT,

---

GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong

0 Answers  

---

What is quality of ipv6?

0 Answers  

---

Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance

1 Answers  

---

plz send me cisco contact no india?

0 Answers   3i Infotech, Cisco,

---

Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers  

---

LMI operates between the Frame Switch and what other device? A.) CPE device B.) Another Frame Switch C.) X.25 switch D.) Novell File Server

1 Answers  

---

Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename

2 Answers   HSBC,

---

Choose the following that are benefits to segmenting with router: A.) Flow Control B.) Manageability C.) Multiple Active Paths D.) Explicit packet lifetime control

1 Answers  

---

Which protocol comes under hybrid dynamic type?

0 Answers  

---

Dear Mr.Shahin thank you very much for your advise i realy thanks full to you. Best of luck

2 Answers  

---

Explain the types of ethernet?

0 Answers  

---