Answer / gcn

high calorific value higher flash point temp. and lower
fire point temp.and environmental friendliness non toxic,etc

Answer / manu

should not produce harmful gases and low ignition point easy
to store,convenient to transport

Answer / aj bolt

*high calorific value
*moderate ignition temperature
*low moisture content

Answer / ramesh

Dencity,viscosity,flash point,fire point,pour point,high calorific value,high octane no.etc...

how to know the direction of a flow in a pipe line in a room without using pressure gauge?

1 Answers   ATS,

---

what is your expectation

0 Answers   TIPL,

---

pls send the technical question paper

0 Answers   Goodrich, HAL,

---

What do you analyze from boiler water analysis?

0 Answers   ABC Inc, RRB, Siemens,

---

What is the Full form of AIF in Compressors ?

5 Answers   MAHINDRA,

---

What is the difference between proof resilience and modulus of resilience ?

0 Answers  

---

What is the difference between vertical and horizontal multistage centrifugal pump? which one has more advantages on the other?

3 Answers  

---

What are the symptoms of broke piston ring?

0 Answers   RRB,

---

When I use two metal wire dowsing rods and walk over the septic tank,(or any other place where the ground has been dug up) they swing apart. What force causes them to move? magnetic, electrical, other?

1 Answers  

---

explain simple accumulator?

2 Answers  

---

Which pipes are used for steam lines?

0 Answers  

---

Q : How to calculate cooling water pumps head, do I need to consider static head and frictional loss of the pipe with high elevation? I mean to say is discharge pipe branches to several elevations and joins to the cooling water return line. The highest elevation pipe goes to a heat exchanger at (xx) psi inlet pressure. Should I consider only pump discharge header and this piping for head calculations? How about frictional losses in return pipe? Pressure recovered in return piping is good enough to make it back to the cooling tower?

1 Answers  

---