Answer / v.ramakrishnan

Amlitude modulation gets more affected by noise in
comparison to FM signals.Since Ear can hear the minute
distortions in audio signals,hence they are transmitted
through FM transmission.Whereas video signals with minute
distortions doesnt show any difference when displayed on
screen.

Answer / andrew lyner

Most of the above is very very dodgy; do not take it seriously. Go elsewhere for proper answers.
FM was (and still is) frequently used for transmitting TV signals. All Satellite TV transmissions (before Digitial came along) used FM. It is much easier to produce high power FM than high power AM, in a satellite, because klystron amplifiers and TWTs are not linear amplifiers.
The reason for using FM for analogue TV sound is that you have enough available bandwidth to give you a better signal to noise ratio with the permitted sound power .
And read more than what I have written.

Answer / sunakal

if we use f.m for video signals in t.v. what will happen?

Answer / hashim mlekwa

this is because a videoia larger than the audio thus it
require enough time to process it therefor it uses AM,on
the other hand an audo is small as compared to the video
therefor it require less time to process it thus why it
uses fm

Answer / mounis

and one more reason lies is.
the AM signal takes more time to transmit and FM less time to transmit and reach the receiver so in order to match the picture with the sound.
such kind of a transmission is used.

Answer / anand

No,FM is't possible for video,Just amplitude modulation uses for the video,there are in a tube there are the two frequency receiver altar high and the lower and both are depends in intermediate Frequency which is received by Yagiuda Antenna.

Answer / ashish

no becoz in FM video signal cant transmited..

Answer / sonia

correct ans

We have 6.6 KV, 250 KW HT Motor and i want to run this motor with 250 KW LT Variable frequency drive. Is this Possible? How? what are the major modification required?

0 Answers  

please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI}}} TECHNICAL question papers TO MY EMAIL ID megalasri@gmail.com I AM BE APPEARING STUDENT CAN I FILL THE FORM OF SECTION ENGG i have to face written test of rrb for the post of J.E (signal), so please send me the old/model question papers for this post to my e-mail ? electronics).for tecnical test question which book is preferred. Railway recruitment board (Changighar examination 2006 & 2005&2004 question papers. Wtion to Your Friend] RRB examination.so which book I have to refer?

0 Answers  

will anyone pls tell me which is the best institue for oracle certification and approx fee for that in banglore....

0 Answers  

where and why do we use stright and cross cable?

0 Answers  

What does the pinch off voltage refers to in a mosfet?

0 Answers  

Explain what are edge triggered flip flop and level triggered flip flop? How do they differ from one another?

0 Answers  

What are the types of cyclo-converters?

0 Answers  

What is the basis for classifying a material as a conductor, semiconductor, or a dielectric? Define what is the conductivity of perfect dielectric?

0 Answers  

What is hole theory

0 Answers  

What is the forbidden energy gap? How does it occur? Define what is its magnitude for ge and si?

0 Answers  

Draw and explain a mod-10 counter.

0 Answers   Ciena,

what is the main defference between analog and digital circuits?

3 Answers   Astra,