Which is the pin no of CN1 TERMINAL and the parameter using
in delta servo drive for auto/man input and start forward
input
No Answer is Posted For this Question
Be the First to Post Answer
what is meant by modulation?
Sir, I hav applied for the post of sec. engg in RRB in telecom-sigal domain. Can u suggest hows the question pattern. Do I hav 2 follow technical books or general aptitude books ?
Void main() { If(printf("C") && getch ()) } Then output is C. If I wrote clrscr() in the place of getch() then it gives error message why..
Explain why is the diffusion technique of formation of resistor most widely used?
why should i hire u?
What is monolithic ic?
how we r approching testing\ institutes
What is meant by Location Area?
What is Micro Controller and Micro Processor. What is the difference between the two
Draw the block diagram of a 128 line EPABX and explain its operation?
What is a dsp?
Explain what is pulse logic system?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)