Answer / dhikale yogesh r

double shear

Answer / p.manokaran

The most common mode of failure is overloading. Operating
forces of the application produce loads that exceed the clamp
load and the joint works itself loose, or fails
catastrophically.it occur in the shear forces and twisting
moment....

Answer / arpitakar

the weakest part of knuckle joint is the key and it can fail by both crushing and shear action whoever is maximum in that technicaly

resistance is the property of a material to resist the flow of current... now by ohm's law current is directly proportional to voltage. then why we transformer in small appplication... if we use resistance in daily life it will be more sufficent,cheaper,etc. than transformer

2 Answers  

---

encoder definition

8 Answers   Base Automation,

---

can anybody can explain about the plc memory types?

1 Answers  

---

What are optical encoders?

0 Answers  

---

State differences between PLC and logic cards?

0 Answers  

---

hi, recently i heard about a control devise called impulse switch which is used in industrial control systems .. could you help me about it because i couldn't find any thing about. thanks,

1 Answers  

---

What is difference between PLC and Logic Card?

1 Answers  

---

In which system does the output not affect the process in any way?

0 Answers  

---

What is the work of accumulator in 8085?

0 Answers  

---

Differentiate between feedback and feedforward control systems?

0 Answers  

---

Would you say me, selecting mechatronics engineering will be useful to my career in this present society?

0 Answers  

---

in ranking cycle why steam is condenset in condensor

0 Answers   Mepco,

---