what are the alignment methods for any two turbine shafts and formulae

2 Answers  

---

Sir can u send me few interview questions and answers based on Deputy Superintendent(materials) of APSRTC. I have selected in written.reply to bhanudammoju@gmail.com thank u.

0 Answers  

---

what is the difference between codes,standards, specification?

6 Answers   CGC, L&T, Philips,

---

Which element causes difference in higher and lower heating values of fuel ?

0 Answers  

---

why the head portion of the screw jack (which carries the load when not rotating) is made hollow?

0 Answers  

---

What is the purpose of a turning gear?

3 Answers  

---

DURING STEAM BLOWING OF PIPE LINE, A BLUISH COLOR CONICAL PATTERN IS OBSERVED AT THE END OF PIPE. WHATS THE CONCEPT BEHIND IT?

0 Answers  

---

What is meant by reflectivity?

0 Answers  

---

why does polytropic efficiency of a compressor decrease with increasing flow rate ?

0 Answers   L&T, ONGC,

---

What is the reason of turbine actuator hunting

1 Answers   SBBPL, Tata Steel Limited,

---

How to calculate perimeter or area of 'Y' piece duct fittings ?

1 Answers  

---

What is coefficient of contraction?

0 Answers  

---