2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

what is the difference between rake and rack.

13 Answers   Bhel,

---

How to find the max load of the engine?

0 Answers   Eicher,

---

What is code used in process piping system?

4 Answers  

---

What are the parts inside hydraulic pump and which parts will be wear and tear ?

2 Answers  

---

What is meant by mechanical engineer? Or who is mechanical engineer?

4 Answers   Engineers India, Engineers India Limited,

---

Mention stefan boltzman contant.

0 Answers  

---

Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?

0 Answers  

---

Is expansion valve a throttle valve? why? and what is the capillary tube and the difference between it and the above ones?

5 Answers  

---

Hindustan petroleum placement papers.please send me.

2 Answers   HPCL, HSBC, NTPC, Satyam,

---

What are the 3 parts in indicator diagram?

0 Answers  

---

What is a continuous carbonization furnace?

1 Answers  

---