1. For Steam drum level signal, why do we compensate with
drum pressure signal?
2.For main steam Flow signal is comensated with main steam
temperature signal and main steam pressure signal why?
No Answer is Posted For this Question
Be the First to Post Answer
You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Hi at present i m wrking with tire industry as a manager having gud ctc. Nw I am selected for 1 of the best chemical industry but my ctc is lower than current n also i hv 2 compromize vit post as post is also lower. I hv 6 yrs of exp in various type of industry. Should i join chemical industry as there ar lot of gud instrument than tire? Financialy i can manage 4 more 2 yrs. Bt during wrking vit tire industry i found there is very less instrument n feel that opportunity is less. Pl ans quickly. I have less time to decide.
how is work pressure switch& level switch?what is the principle of this?
What is the working principal of Mass flow transmitter?
How to Calibrate the magnetic flow meter on site ?
What are different types of control valves?
why we r opening HOT BYPASS valve during startup of a compressor?
1,why we use 4-20 ma output of all instrument qhy not use 0- 20, 2,what is the different between PLC & DCS. 3,how can we meaure maximum span of new flowmeter if not given any information.
What is the differences of Level swich( LS ) and Level Transmitter(LT)
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
What is the difference in clamp on type and inline type ultrasonic flow transmitter.