Why we use signal&voltage isolator between source n load.

Question Posted / d.kapil

3 Answers
6307 Views
Bhel, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why we use signal&voltage isolator between source n load...

Answer / pinky

to avoid the back flow of signal 4m load 2 source... tis
avoids interference...

Is This Answer Correct ?

13 Yes

0 No

Why we use signal&voltage isolator between source n load...

Answer / vasudev

its jus to avoide the the reflection from load to source.... i.e to avoid load from high freq source

Is This Answer Correct ?

5 Yes

0 No

Why we use signal&voltage isolator between source n load...

Answer / n.babu

to avoid the back flow of signal 4m load to source that is
it is avoid interfrence

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

What is Cell Splitting?

0 Answers

Explain the approximate cost of the monitoring cables time domain reflectometry?

0 Answers

Realize a RS flip flop using a JK flip flop.

1 Answers TCS,

Define what are the main purposes for which a cc amplifier may be used.

0 Answers

Hi.im IMRAN.Im pursuing my B.tech final yr.plzzz any 1 guide that vich course shud i take in telecom.either protocol development or protocol testing or hardware plzzzz tell me n hz this important in future n why shud i take.plzzzzz its my request u to send this answer.thnx bro i vil wait for u r answer.k.byeeeeeee

1 Answers

what is meant by differential amplifier? what is primary function?

2 Answers

• The silicon of a new device has memory leak. When all "0" are written into RAM, it reads back all "0" whithout any problem. When all "1" are written, only 80% of memory cells are read back correctly. What can be possibly the problem with the RAM?

0 Answers

The peripherals of the computer(like keyboard, monitor) are connected through buses directly or is there any interfacing device present in the CPU?

3 Answers NTPC,

the maximum spectral response of the germanium and silicon is in the ?

3 Answers BSNL, HCL,

Hi dears, i work with E// switches since a bit time,i faces a problem with AFFILE output,when i get the out put (with Hex code) and i try to convert it to ASCII code it gives me the correct values but the data is not arrange correctly,there is some tabs,spaces and by result the data is shifted is there any advice for this case thanks & regards

0 Answers Ericsson,

on what basis hardware and software interrupts are defined

5 Answers

Explain why bjt is called current control device?

0 Answers

For more Electronics Communications Interview Questions Click Here