Answer / dinesh

EARTHING IS REQUIRED FOR HUMAN AS WELL AS MACHINE SAFTY
WHEN EVER THE LEAKAGE CURRENT FLOW IN THE CIRCUIT .IT PASS
THROUGH THE EARTHING CIRCUIT AND MAKE THE POTENTIONAL
DIFFRANCE ZERO .FOR THIS EARTHIN RESISTANCE IS GOOD AS
LESS AS. APROXIMAT 1 OHM. IS GOOD.

Answer / sangram

earthing is required for machine safety and very important
for human safetywhen leakage current flow should be pass by
earthing.so not danger for anything.any equpment,machine
any electrical equpment must be provied eathing.without
earthing this is not safe.

how to calculate overall efficiency of diesel generator set? give us a formula with an example.

2 Answers  

---

the fuse is use for protection against overcurrent but at normal condition it carry the rated current then how single thin wire carry this current without melting

1 Answers  

---

Y phase plates are used in transmission line??? what is there need???

0 Answers  

---

Any link for Electrical objective type questions ?

0 Answers  

---

what is the ranje of HT cabel and LT Cabel.

1 Answers   Sail,

---

What will be the current if the resistance total in a series circuit doubles?

0 Answers  

---

what is a circuit breaker. Weite the types of circuit breaker.

4 Answers  

---

Hi to u all : Friends: Why when operate on 2 phase welding machine the power metr goes reverse ?? the meter is god on other loads. thanks

2 Answers   Gedco,

---

2 t/f operating in parallel will share the load according 2 their- a)leakage reactance,b)pu impedence,c)efficiency,d) rating.

1 Answers  

---

what is necessity of using isolation transformer?

4 Answers   NTPC,

---

what is meant by line voltage and phase voltage in a three phase transformer?

2 Answers  

---

define IDMT relay?

15 Answers   APGenco, Bhel, L&T, Shriram Finance,

---