what is differnace between radar level tranmitter & hart
type tranmitter?
Answers were Sorted based on User's Feedback
Answer / vaibhav v t
radar is the non contact type level transmitter which works
on the principle of electro-magnetic waves of frequncy in
the range of 3Ghz to 25 Ghz.
Hart is the protocol for digital communication.
Radar is available with HART protocol.
Is This Answer Correct ? | 13 Yes | 0 No |
Answer / rajesh kumar
Radar type level transmitter works on the principle of FMCG
(frequency modulated continious wave system) & hart
transmitter works on the principle highway adressable
remote transducer the data is transmitted from the sensor
to the requred system through the hart adress
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / afsar mumtaz
radar inst is used for to calculate level of material
radar are 2 type
1-pulse and fmcw,
2-up to 6GHZ to 74GHZ
3-liquid ,solid,powder,dust and slurries,
HART ,highway addressable remote transducer for calibration of field inst.
Is This Answer Correct ? | 0 Yes | 0 No |
how can calibrate pressure transmeeter in the feild ?
Q- Which of the following is Close loop system - a-)respiratory System b-)traffic light system c-)washing machine d-)Room heater my option is A, what is our take on option B & C
What are the problems faced while testing HART instruments?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
What are the different type of instrument used in cement industry with uses
What is the working principle of sox, nox analyzer?(opacity monitor) Otherwise how to measure the sox,nox?
Define magnetic flow meter and mass flow meter.
what is the process to make control schematic ?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What is the reason PT speed not incresed in gas turbine?
why using 4-20ma not using 0-20or why not using 1- 20ma???????