pls suggest me a good institute for loadrunner in hyderabad
also what about a practice project?
- 15 Answers
- 16313 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / balaji
Best institute for Load Runner in hyderabad is TESTQ
TECHNOLOGIES. they are giving training with practical
project exposure. It is near Nargarjuna school, SR
Nagar.Ph:040-64567966, 9966048282.
Their teaching methodology is best in hyderabad and have
computer classroom. i.e you can practice Loadrunner in class
room itself while faculty explaining.
| Is This Answer Correct ? | 4 Yes | 7 No |
Answer / shyam
MindQ is the best institute in Hyderabad for training in
LoadRunner. Located above HDFC bank in SR Nagar. The
faculty Shyam is very experienced and gives very practical
training and knowledge.
| Is This Answer Correct ? | 2 Yes | 5 No |
Answer / ashok
gottimukulla suresh is their hi yhe reail time expert on loadrunner his8686808680 no is
| Is This Answer Correct ? | 0 Yes | 5 No |
Answer / charan
we are also taking classes on L.R in siri technology better
to move that institute.This institute is beside the nihar
diagnostic center in mythrivanam.
| Is This Answer Correct ? | 0 Yes | 7 No |
)what is web protocol& webservices protocol .Can u just give the examples.
what is the language(Script) use in Loadrunner script?
What is performance testing in loadrunner?
if throughput graph shows low and high than what will u do?
HI Any one can say the how to use the loadrunner to test the application. How to write the test scenarios & test cases.
What is the use of "swing time" in Load Runner?
Hi, I'm trying to measure page load times in a web app. How do I verify that the page I go to next is fully loaded? Do I use content verification (web_reg_find)? I am measure the time it takes for a page to load and then the user goes to another page and another and so on. I need to know how long it took for page one. How long it took for page two and so one. I'm using transactions for each page, but I want to make SURE that the page is fully resolved/loaded before the scenario goes to the next page. So, does LoadRunner automatically do this or do I have to use content verification or do I do it in some other way? Thanks, Brian
what is standalone mode running?
Can anyone please mention what are the common errors that we can see while replaying the Vugen script and also while running the controller scneraio and How to handle them with a few examples. This will be greatly helpful.
What is maximum No of Vusers that we can load using LoadRunner8.0 and how should we connect to database using loadrunner
Where do you set automatic correlation options?
What is the difference between Group and Scenario in Load Runner Controller terminology?
WinRunner 
