WHAT IS RESISTOR?
Answers were Sorted based on User's Feedback
Answer / mohan
it is a device which opposes the flow of current and the
property of oppose is called resistance
Is This Answer Correct ? | 16 Yes | 2 No |
Answer / siva subrahmanyam
Resistance is the property of a material which opposes the
flow of current through that material and absorbs some
energy from that electron flow in the form of Voltage drop.
Diffrent materials have different resistances.
Is This Answer Correct ? | 11 Yes | 2 No |
Answer / chandrashekar.a
Resistor is a device. It is opposse and limits the flow of
electrical cuurent in a coductor
Is This Answer Correct ? | 5 Yes | 1 No |
Answer / sam
IT IS A TWO TERMINAL ELECTRONIC COMPONENT WHICH PRODUCES A VOLTAGE ACROSS ITS TERMINAL WHICH IS PROPORTIONAL TO THE ELECTRIC CURRENT PASSING THROUGH IT FOLLOWING THE OHM'S LAW -
V=IR
OR
IT IS A DEVICE WHICH OFFERS THE HINDERENCE AN OBSTRUCTION IN THE PATH OF CURRENT FLOWING THROUGH IT.
ITS CHARCTERSTICS ARE
1.RESISTANCE
2.TOLERENCE
3.MAXIMUM POWER
4.POWER RATING
Is This Answer Correct ? | 4 Yes | 1 No |
Answer / trilok gupta
resistor is a device is control the flow of current
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / dileeep goyal
A resistor is a two-terminal electronic component which
implements electrical resistance as a circuit element. When
a voltage V is applied across the terminals of a resistor,
a current I will flow through the resistor in direct
proportion to that voltage. The reciprocal of the constant
of proportionality is known as the resistance R, since,
with a given voltage V, a larger value of R
further "resists" the flow of current I as given by Ohm's
law
Is This Answer Correct ? | 1 Yes | 1 No |
can any one tell us exact bandwidth of any AM power station???
why the backwheel of tractor is bigger than frontwheel?
plzz send in detail with answers of rrb section engineers model paper to my mail id sir.
what is main difference between gsm & cdma
Hi; May you please tell me that There are any best institute or training center in north India region like as Delhi NCR for Protocol stack development & testing, which are better for experienced & professional engg.
what is perfect balance in opamp?
which is the best institute in india to get trained on telecom protocol testing?
why passive components are used in pre emphasis and de emphasis?
What precautions are required to be observed in the use of leds?
why in 8085 microprocessor some address and data bus are same help me ...
why nand-nand realization is preferred over and-or realization?
WHEN SUB. A IS HPLMN AND B SUB. IS ROAMING FROM ANOTHER PLMN CAN ANY ONE TELL ME THE CALL FLOW FOR THIS?