What is the minimum setup needed to start using jquery.

920

What all verticals have you handled in your seo career so far?

934

What is the use of actions in qtp tool?

62

Define the overload capacity of the motor?

2128

IF i have two columns in Database , While using Database output value ,allthe values in the two column are set as a single row in the QTP datatable, can u suggest me a idea so that QTP Runtime datatable displays the values as it is in the database

2057

where can i get 4.1 computer science test papers

2436

hii.plz send me hpcl placement papers for officers trainees for graduate engg plz my email id is ajm_knit@yahoo.com

2349

could u pls anyone tel me .."which is the best instute that provides eficient practical knowledge and also real-time oriented knowldge to do a project in manual and automation testing..in hyd" pls send me to dis mail-id if u find any..? sinducute17@gmail.com

2251

Hello everyone, can any one please give me the full configuration step by step of COPA in CO.It's very urgent. Plz send it to my mail id- sandip.palit81@gmail.com Thanks in advance.

2221

Who is your guide ?

1273

What is the per cu. mt. price of ready mix in Gujarat region.?

2412

A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

2236

can any body plz help by sending the qtp docs and qtp ppt's? this is my mail id:murali.padeti@gmail.com

2314

i need qtp tutorial. pls send it to sridhar.k151@g mail.com

2164

Please some one tell me what is the VAT or WCT rate for works contract at Tripura

2578