Answer Posted / vijay
power fector is a angal bitween v&c
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
What are the advantages of stationary armature and rotating field system?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
How many types of instrument cables are there?
What is meant by reverse polarity and how it can be fixed?
Why is a plain induction motor unsuitable for wide speed control?
whats the existence of reactive power and when it arises?
comparision between ACB and VCB
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
what is meant by skew width in machines?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
how to calculate current and voltage in a same circuit?
Earth has zero potential then what would be the neutral potential ?
How to see the inductance in a transmission lines
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
