why C.T secondary are rated 5A generally?
Answer Posted / arun
The CT has separate primary and secondary windings. The
primary winding which consists of few turns of heavy wire,
wound on a laminated iron core is connected in series with
one of the line wires. The secondary winding consists of a
greater number of turns of a smaller size of wire. The
primary and secondary windings are wound on the same core.
The current rating of the primary winding of a CT is 100 A.
The primary winding has three turns and the secondary
winding has 60 turns. The secondary winding has the
standard current rating of 5A;therefore the ratio between
the primary and secondary current is 100/5 or 20/1.The
primary current is 20 times greater than the secondary
current. Since the secondary windings 60 turns and the
primary winding has 3 turns, the secondary winding has 20
times as many turns as the primary winding. For a CT the
ratio of primary to secondary currents is inversely
proportional to the ratio of primary to secondary
turns..this 5A s the standard fixed by the electricity
corporation and they folow t..so its a convention to follow
this standarrdd
Is This Answer Correct ? | 11 Yes | 19 No |
Post New Answer View All Answers
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
why impudance relay used for medium transmission power system? why not others?
what are the breakdown voltage rating of mini- curcuit'transfarmer!
What is difference between Harmonic and Non harmonic Capacitor Bank?
bus bar design conditions and sizing pls tell me quickly
which connection is safer series or parallel?usually which connection we prefer at home?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
how we findout a ignater is faulty or not?
what is excitation/
what is the difference between ac motor and dc generator
What are the disadvantages of hydropower?
What is lc oscillator?
surge tank, hrc fuse, earthing transformer, firm power objective type